Page 45 - Catalog spare parts BPW brake disc
P. 45
AUTO PARTS
Page 45 - Catalog spare parts BPW brake disc
Auto Parts / Page 44 BPW-EL-TSB 31231601e
4 Hubs, hub bearings
4.5 Grease filling, bearing adjustment
ECO Plus 3 hub system (ECO Plus 3 Unit)
Grease filling per wheel hub ECO Plus 3 hub system (ECO Plus 3 Unit)
The ECO Plus 3 hub system is designed for the use of longlife grease. On expiry of the guarantee, the roller bearings, the inside
of the hub and the seals are to be thoroughly cleaned (with diesel oil), dried, checked to see if they can be re-used; and re-greased
every three years when used off-road, or every 5 years when used on the road, within Europe (or every year when off-road and every
two years when on the road outside of Europe) (observe the current BPW maintenance instructions).
Apply BPW ECO-Assembly and Protection Spray as thin as possible and around the entire area of bearing seats of the axle stub.
BPW longlife roller bearing grease ECO-Li Plus ,
Quantity per tapered roller bearing
1 inner 2 outer
Axle load Axle type Roller bearings Quantity Roller bearings Quantity
SH.. 8 - 9t ECO Plus 3
8000 - 9000kg 33118 130 g 33213 90 g
SK.. 9 - 9t ECO Plus 3
1 Clean the grease cartridge and fi ll it on both sides up to the edge with BPW longlife roller bearing grease ECO-Li Plus .
+ Apply a ring-shaped bead of grease to the running surfaces of the outer bearing races.
2 Apply a coat of BPW longlife roller bearing grease ECO-Li Plus all around the lip of the seal.
For other procedures see the current maintenance instructions.
When BPW grease applicators are used there is no need to fi ll the grease cartridge or to apply the bead of grease.
Greasing with grease spray see page 42.
Bearing adjustment ECO Plus 3 hub system (ECO Plus 3 Unit)
1. Unscrew the hub cap.
2. Remove the hooked spring ring and retaining key from the axle nut.
3. Use a spanner to tighten the axle nut whilst at the same time turning the wheel hub, until the axle nut torque
limiter operates (do not use an impact driver).
4. Fit the retaining key in the groove between the axle stub and the nut (do not reset the axle nut).
5. Insert the hooked spring ring, depending on the version, behind the fl ange on the axle nut or in the
thread on the axle stub.
6. Insert a new ‘O’-ring into the groove in the wheel hub.
7. Screw on hub cap and tighten to 350 Nm.
