Search the database of auto parts codes

     

     

     

     

     

    previous

    Page 59 - Catalog spare parts BPW HKN
    P. 59
    Catalogs auto parts for car and truck

    AUTO PARTS

    Page 59 - Catalog spare parts BPW HKN

    Auto Parts / BPW-EL-HKN 31021701e                                                                               Page 59
    
                                                                           Hubs, hub bearings                          5
    
    
                                                                                                      General
    
    
    
    
                Hub cap / ECOMETER
                BPW trailer axles with the ECO Plus 2 unit have hub caps
                (and ECOMETERS) with a bayonet fitting.                                                                     H
                The bayonet fitting replaces the previously usual threaded
                connection.
                A 120 mm installation spanner (BPW part number                                                              K
                03.339.05.02.0, see also BPW tool catalogue) is needed
                for fitting or removing the new hub caps with the bayonet
                fitting.                                                                                                    N
                 +    An impact driver must not be used for
                      fitting / removing hub caps or ECOMETERS
                      with a bayonet fitting!
    
                Removal
                To remove the hub cap it is turned anticlockwise through
                approx. 30 degrees with the installation spanner (Fig.).
                When turned further, the hub cap lifts clearly away from
                the hub seat.
                The released position is also indicated by markings on
                the hub cap and on the wheel hub (Fig. / Arrows).
                In the released position the hub cap can be removed from
                the wheel hub by pulling it away.
    
    
    
                                                                                Dismanting
                Assembly
                The seal between the hub cap and the wheel hub takes
                the form of an O-ring in the case of the ECO Plus 2 unit.
                The O-ring is inserted in the groove on the hub collar of   Assembling
                the wheel hub, and is to be replaced every time. The hub
                cap itself is to be given a thin coating of BPW ECO-Li Plus
                special long-life grease inside in the area of the bayonet
                fitting, before assembly.
                Corresponding markings in the hub cap and
                on the hub make it easier to fit the hub cap.
                The figure shows the hub cap in the correct position
                for fitting, with the spanner engaged. After been
                placed in position, the hub cap is pressed onto the hub
                and at the same time turned in clockwise direction.
                The hub cap is firmly in place when the position shown
                in Fig. (arrows) has been reached.
    
    
    
                                    
    previous
       54   55   56   57   58   59   60   61   62   63   64
    Current Page
    next

     

     

     

     

     

    next